Suunto Vector - Selecting the Units of Measurement

12
MEASUREMENTS AND UNITS
Note: This setting applies to the Altimax, Vector, and X-Lander.
The Wristop Computer supplies two units of measure: metric or imperial.
Metric Unit of Measure Imperial Unit of Measure
mft
m/min ft/min
O
C
O
F
mbar inHg
Selecting the Units of Measurement
To change the unit of measure displayed:
1. Check the mode indicator. If the mode arrow is not on TIME, PRESS the [Mode] button until the arrow
is directly below TIME on the Mode Indicator Bar.
2. PRESS the [Mode] and [Select] buttons simultaneously and hold for 3 seconds. Field 1 will display
SET momentarily and then display UNI.
Note: If the user does not press any button for 1 minute in the setup mode, the display will automatically
exit setup.
WARNING: If the user presses the [Select] button (and does not hold for 2 seconds) while in the UNI
setting mode, the user will be in the Pressure Sensor Calibration. Refer to the next section for details.
3. PRESS the [Select] button and hold for 2 seconds. Located to the right in Field 2, m or ft will begin
to flash.
4. PRESS the [+] button to toggle between m and ft.
5. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located below the
m or ft in Field 2, mbar or inHg will begin to flash.
6. PRESS the [+] button to toggle between mbar and inHg.
7. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located at the top
right in Field 1 (just above the bubble),
O
C or
O
F will begin to flash.
8. PRESS the [+] button to toggle between
O
C and
O
F.