Suunto Vector - STOPWATCH MODE; How to Use the Stopwatch

18
STOPWATCH MODE
Note: This feature applies to the Altimax, Vector and X-Lander models.
The Wristop Computer stopwatch feature can provide split time measurement and two finish times up
to 23 hours 59 minutes and 59 seconds.
In the TIME mode, PRESS the [Select] button twice to enter this sub mode.
In the Stopwatch mode,
 Field 1 displays the seconds and tenths of a second,
 Field 2 displays the current time, and
 Field 3 displays hours and minutes and to the far right stopwatch.
How to Use the Stopwatch
There are three timing modes the user can employ:
 an elapsed time measurement;
 a split time measurement; and
 a two finish time measurement.
In the elapsed time mode:
1. PRESS the [+] button to start, stop, and restart the stopwatch.
2. PRESS the [-] button to reset the stopwatch to zero once the stopwatch has stopped.
In the split time mode:
1. PRESS the [+] button to start the stopwatch.
2. PRESS the [-] button once to stop the stopwatch and to display a split time.
3. PRESS the [-] button a second time to release the split time display and resume the stopwatch.
4. PRESS the [+] button to stop the stopwatch.
5. PRESS the [-] button to reset the stopwatch to zero once the stopwatch has stopped.