ELECTRICAL SYSTEM 7-27
FUEL LEVEL METER
• Lift and support the fuel tank with the fuel tank prop stay.
(!4-51)
• Connect each resistor between the Yellow/Black and Black/
White lead wires at the wire harness.
• Turn the ignition switch “ON” position and wait for approx. 13
seconds.
Check the display of fuel meter as shown below, If any abnor-
mality is found, replace the combination meter with a new one.
OIL PRESSURE INDICATOR
NOTE:
Before inspecting the oil pressure switch, check the engine oil
level. (!2-13)
• Remove the engine under cover.
• Disconnect the oil pressure switch lead wire from the oil pres-
sure switch.
• Turn the ignition switch “ON” position.
Check if the oil pressure indicator will light, when grounding the
lead wire.
E
F
E
F
E
F
E
F
E
F
E
F
Resistance
More than
167 Ω
Less than
21 Ω
115 – 167 Ω
73 – 115 Ω
45 – 73 Ω 22 – 45 Ω
Fuel level
meter
To oil pressure
switch
To Next Page
Loading...
