Suzuki DL1000 - Page 60

3-14 ENGINE
• Put the drive chain on the driveshaft.
• Gradually raise the engine assembly and align all the bolt
holes.
• Install the engine mounting bolts and bracket bolts, and
tighten them temporarily.
• Tighten the engine mounting thrust adjuster and its lock nut to
the specified torque with the special tool.
$
Engine mounting thrust adjuster: 12 N·m (1.2 kgf-m, 8.5 lb-ft)
Engine mounting thrust adjuster lock nut:
45 N·m (4.5 kgf-m, 32.5 lb-ft)
" 09940-14990: Engine mounting thrust adjuster socket
wrench
• After tightening the engine mounting bolt
A, tighten the pinch
bolt
B.
$ Engine mounting bolt
A: 55 N·m (5.5 kgf-m, 40.0 lb-ft)
Engine mounting pinch bolt
B:
23 N·m (2.3 kgf-m, 6.5 lb-ft)
• Tighten the engine mounting bolt to the specified torque.
$ Engine mounting bolt
C: 55 N·m (5.5 kgf-m, 40.0 lb-ft)