ENGINE 3-21
STARTER MOTOR
• Remove the starter motor.
\
• Remove the cylinder head nut.
• Loosen the cylinder nuts.
• Remove the oil cooler mounting bracket
1.
• Remove the cylinder head bolts.
• Remove the cylinder head.
NOTE:
* When loosening the cylinder head bolts, loosen each bolt little
by little diagonally.
* To identify each cylinder head, mark the cylinder as the front
and rear, cylinder head uses the same part.
FRONT CYLINDER
• Remove the cylinder.
NOTE:
Firmly grip the cylinder at both ends, and lift it straight up. If the
cylinder does not come off, lightly tap on the finless portions of
the cylinder with a plastic mallet to make the gasketed joint
loose.
To Next Page
Loading...
