3-22 ENGINE
• Remove the cylinder base gasket and dowel pins.
FRONT PISTON
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlip into the crankcase.
• Remove the piston pin circlip.
• Remove the piston by driving out the piston pin.
NOTE:
Scribe the cylinder number on the head of the piston.
REAR CYLINDER HEAD COVER
• Remove the rear cylinder head cover
1.
• Turn the crankshaft to bring the “F | T” line mark on generator
rotor to the index mark of the valve inspection hole and also to
bring the cams to the position as shown.
NOTE:
At the above condition, the rear cylinder is at ATDC 90° on
expansion stroke and also the engraved lines
A on the cam-
shafts are parallel with the mating surface of the cylinder head
cover.
FRONT
Rear
cylinder head
To Next Page
Loading...
