Suzuki DL1000 - Page 76

3-30 ENGINE
• Insert a suitable bar into the holes of primary drive gears to
align the teeth of scissors gears.
• Remove the cam drive idle gear/sprocket and cam chain.
• Remove the key
1.
PRIMARY DRIVE GEAR
• Hold the generator rotor with the special tool.
" 09930-44541: Rotor holder
• While holding the generator rotor, remove the primary drive
gear nut.
#
• Remove the washer
1.
• Remove the primary drive gear assembly
2.
This bolt has left-hand thread. Turning it counter-
clockwise may cause damage.