2A-20 Housing and Bracket:
Oil Strainer
• Inspect the oil strainer. Replace the strainer if
cracked, damaged or other abnormal conditions are
found.
If clogged or obstructed, clean the oil strainer.
• Check condition of O-ring. Replace O-ring if nicked,
cut, worn or other abnormal condition are found.
Oil Pan / Driveshaft Housing
• Check oil pan, driveshaft housing.
If cracks, defects or other damage is found, replace it.
Mount
• Check upper, lower and thrust mounts.
If excessive wear, corrosion or other damage is found,
replace mount.
• Inspect mount cover. Replace mount cover if cracked,
damaged or other abnormal conditions are found.
Water Tube / Water Tube Grommet
• Check water tube.
If a clog or obstruction is found, clean water tube.
If cracks, corrosion or other damage is found, replace
water tube.
• Check water tube grommet.
If excessive wear or other damage is found, replace
grommet.
To Next Page
