Differential: 3B-14
9) Apply thread lock cement to thread of breather cover bolts (5).
10) Upon completion of gear tooth contact check in Step 8), after applying sealant to breather cover (3), install
breather plug (2) to differential cover (4).
11) After applying sealant to differential cover (4), install differential cover (4) to differential carrier (1).
“A”: Sealant 99000–31260
“B”: Thread lock cement 99000–32110
Tightening torque
Breather cover bolt (b): 6.0 N·m (0.6 kgf-m, 4.5 lb-ft)
Differential cover bolts: 23 N·m (2.3 kgf-m, 17.0 lb-ft)
12) Caulk bevel pinion nut (2) with caulking tool (1) and hammer.
Rear Differential Inspection
S3RH0A3206007
• Check companion flange for wear or damage.
• Check bearings for wear or discoloration.
• Check differential carrier for cracks.
• Check drive bevel pinion and bevel gear for wear or cracks.
• Check side gears, pinion gears and pinion shaft for wear or damage.
• Check side gear spline for wear or damage.
I3RH0A320002-01
I3RH01322050-01
To Next Page
Loading...
Need help?
General
