AMI Codes-II
Program List and Explanations
A-96.250.571 / 050517 77
2.3 Sample
2.3.1 Sample ID: Shows the identification assigned to a sample. This
identification is defined by the user to identify the location of the
sample.
Sample Flow: Shows the actual sample flow in B/s (bubbles per
second)]. The Sample flow must be above 5 B/s.
Temperature: Actual temperature in °C and in Ohm (NT5K)
2.4 I/O State
Shows current status of all in- and outputs.
2.4.1/2.4.2
2.5 Interface
Only available if optional interface is installed.
Review programmed communication settings.
Alarm Relay: Active or inactive
Relay 1 and 2: Active or inactive
Input: Open or closed
Signal Output 1 and 2: Actual current in mA
Signal Output 3: Actual current in mA (if option is installed)
To Next Page
Loading...
