1. GENERAL INFORMATION
1-15
E. CLUTCH AND DRIVING PULLEY
Clutch lining spring broken
Clutch outer stuck with clutch balance weights
Connection parts in clutch and shaft worn out or burned
Engine can be started but
motorcycle can not run
FAULT CONDITION PROBABLE CAUSES
Driving belt worn out or deformation
Driving disk damaged
Driving pulley spring broken
Clutch lining broken
Driving shaft groove broken
Transmission gear damage
Transmission gear worn out or burned
Engine running and misfire as
motorcycle initial forward moving
or jumping sudden (rear wheel
rotating as engine in running)
Poor initial driving (Poor climbing
performance)
Driving belt worn out or deformation
Balance weight roller worn out
Driving sliding gear shaft worn out
Driving disk spring deformation
Driving sliding gear shaft worn out
Greased in driving belt and sliding gear.
To this chapter contents
To Next Page
Loading...
