16. Steering / Front Wheel / Front Cushion
16-7
Wheel rim
Place the wheel rim on a rotary rack.
Rotate the wheel rim and measure the runout.
Service limit:
Radial: 2.0 mm
Axial: 2.0 mm
Disassembly
Remove the bushes and dust-proofing oil seal.
Insert the bearing puller into the bearing and pull
out the bearing.
Remove the spacer and take off the bearing
itself.
Tools
Bearing puller (Inner)
Assembly
Fill the bearing cap with grease
Place the left bearing into the bracket.
Install the spacer and place the right bearing into
the bracket.
Caution
Caution
Tools
Hydraulic presser
Never use the old bearing. It must be
replaced with a new one once it was
removed.
Never incline the bearing when it is installed.
To this chapter contents
To Next Page
Loading...
