Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 - Page 395

Deployment Solution 395
Command-Line Switches
PromptReboot Prompt before executing shutdown and restart
commands.
Example: PromptReboot=Yes.
PromptExecute Prompt before executing program execution and file
copy commands.
Example: PromptExecute=Yes.
PromptRemoteControl Prompt before executing remote control commands.
Example: PromptRemoteControl=Yes.
PromptSeconds Specifies how long the user prompt should appear in
seconds.
Example: PromptSeconds=10.
PromptOverride Specifies whether the AClient should continue the
operation or abort it, when the user prompt times out.
Example: PromptOverride=Continue.
Connection
ConnectionParadigm Specfies whether to select to either stay connected to
the Deployment Server, or check periodically for work.
To remain connected, ConnectionParadigm=0. To
remain mostly disconnected, ConnectionParadigm=1.
Example: ConnectionParadigm=0 or
ConnectionParadigm=1.
UseHardTimeout Specifies whether to refresh connection after idle time
specified in HardTimeout. ConnectionParadigm must
be 0 for this setting to work.
Example: UseHardTimeout=Yes.
HardTimeout Specifies how frequently to refresh the connection to
the server in seconds. ConnectionParadigm must be 0
and UseHardTimeout must be Yes for this setting to
work.
Example: HardTimeout=28800.
ReconnectInterval Specifies how often in seconds to reconnect to check
for work. ConnectionParadigm must be 1 for this
setting to work.
Example: ReconnectInterval=28800.
CloseTimeOut Specifies how long, in seconds, to wait for work before
disconnecting. ConnectionParadigm must be 1 for this
setting to work.
Example: CloseTimeOut=60.
SetSpeedLimit Specifies whether to set speed limit for transfer files. If
it is Yes, check transfer rate is slower than the rate
specified in SpeedLimit. If it is No, do not transfer files.
Example: SetSpeedLimit=Yes.
Parameters Details