5-33
Parameter Menus
Decode UPC/EAN Supplemental Redundancy
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number
of times a symbol without supplementals is decoded before transmission. The range is from
two to 20 times. Five or above is recommended when decoding a mix of UPC/EAN symbols
with and without supplementals, and the autodiscriminate option is selected. The default is
set to 7 times.
Scan the bar code below to select a decode redundancy value. Next scan two numeric bar
codes beginning on page 5-99. Single digit numbers must have a leading zero. If you make
an error, or wish to change your selection, scan CANCEL on page 5-101.
DECODE UPC/EAN
SUPPLEMENTAL REDUNDANCY
To Next Page
Loading...
