Symbol P460 - Host Serial Response Time-Out; RTS Line State

5-92
P460/P360 Memory Scanners Product Reference Guide
Host Serial Response Time-out
This parameter specifies how long the scanner waits for an ACK, NAK or CTS before
determining that a transmission error has occurred. This only applies when in one of the
ACK/NAK Software Handshaking modes, or RTS/CTS Hardware Handshaking option. The
default time is set to 2 seconds.
The delay period can range from 0.0 to 9.9 seconds in 0.1 second increments. After
scanning the bar code below, scan two numeric bar codes beginning on page 5-99. If you
make an error, or wish to change your selection, scan CANCEL on page 5-101.
HOST SERIAL RESPONSE TIME-OUT
RTS Line State
Note:This only applies to the scanner in corded mode. It has no affect
when uploading data through the cradle.
Scan the appropriate bar code below to set the idle state of the Serial Host RTS line.
Choose LOW RTS line state or HIGH RTS line state.
*HOST: LOW RTS
HOST: HIGH RTS