3-1
Chapter 3
Operation
Introduction
This chapter covers how to use the Phaser scanner.
Default Applications
The Memory Phaser is shipped from the factory with two ready to use default applications:
• Scan and Transmit
• Batch / Inventory
These applications allow users to scan and view data, enter quantities, manually enter
data, and much more.
When the unit is powered up, it displays the system start-up banner. Alternatively, the
scanner can be reset manually by pressing the <FUNC> key, then the <*> key. When the
scanner is powered up or reset, the system banner appears as follows:
Symbol Technologies
Phaser Memory Scnr
To Next Page
Loading...
