5-8
P460/P360 Memory Scanners Product Reference Guide
Communication Protocol
The bar codes below set the communication protocol used by the default applications.
• Scan & Transmit application for corded operation
• Batch/Inventory application for uncorded (Batch) operation.
The communication options are RS-232/Synapse or MCL-Net. If you select RS-232/
Synapse, the scanner automatically identifies whether an RS-232 or Synapse interface is
required. MCL-Net allows the scanner to communicate with a host running MCL-Link or
MCL-Link Lite.
The communication protocols for the two default applications can be set independently of
each other.
Note:These communication protocol parameters are only for the Scan &
Transmit and Batch/Inventory applications and will not work with
applications created with MCL-Designer.
Scan & Transmit Application
This communication protocol is used for the real time scanning and transmission of data to
a host when a cable is attached.
*RS-232/SYNAPSE
(Scan & Transmit application only)
MCL-NET
(Scan & Transmit application only)
To Next Page
Loading...
