128 XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
1
Response (one of the following lines):
OK - The Default Gateway has been received and applied by the PTP Option Card<CR><LF>
Setting the Internet Configuration
The three commands, F131 IP, F131 SM, and F131 G, can be concatenated to set all three values
simultaneously. To do so, enter:
F131<SP>B<N><SP>IP<SP><nnn.nnn.nnn.nnn><SP>SM<SP><nnn.nnn.nnn.nnn><SP>G<SP><nnn.nnn.n
nn.nnn>
Note: The three commands (i.e. IP, SM, G) must be entered in the order of IP, SM and G. A colon sepa-
rator ":" can be used instead of <SP> following IP, SM, and G (e.g., IP:192.168.46.150). A mix-
ture of colon and <SP> separators cannot be used.
For example, using appropriate values for your network, enter something similar to:
F131 B4 IP:192.169.46.150 SM:255.255.255.0 G:192.168.46.1
Response:
OK - The Network Parameters have been received and applied by the PTP Option
Card<CR><LF>
The Response messages that the PTP option card can return for the Network Parameters entry include
the OK response previously stated and all the ERROR responses previously stated.
Enable/Disable DHCP
To get the DHCP setting, enter:
F131 B<N> DHCP
Response (example):
F131 B4 DHCP ENABLE IP:10.13.0.100 SM:255.255.0.0 G:10.13.0.1<CR><LF>
Use the following format to enable or disable DHCP on the PTP card’s network port:
F131 B<N><SP>DHCP<SP><SET>
To Next Page
Loading...
