XLi IEEE 1588 Clock 137
997-01510-03, Rev. C, 12/12/2006
2
5
1
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
9: XLi-Generated Messages
Error Messages
ERROR 01 VALUE OUT OF RANGE
You entered a command using the correct format that contained a value, probably numeric, that was
outside the range of acceptable values.
Recovery Action: Re-enter the command using an acceptable value.
ERROR 02 SYNTAX
You entered a valid command, but using the wrong format.
Recovery Action: Re-enter the command, using the correct format.
ERROR 03 BAD/MISSING FIELD
You entered a command that lacks a required field.
Recovery Action: Re-enter the command, using the required fields.
ERROR 04 - BAD DATA/TIMEOUT CONDITION
The GPS option card did not respond to the XLi soon enough.
Recovery Action: Re-enter the command, using the required fields.
ERROR: Invalid Command
You have entered an invalid command.
Recovery Action: Consult the manual for the correct command and re-enter.
ERROR: Can’t create netdevice <NAME>
The XLi can not create the device needed to map the host to a drive.
Recovery Action: Restart the Unit. If this error message persists, contact Symmetricom Technical
Customer Service.
ERROR: Can’t set host <NAME> ip <ADDRESS>
You have incorrectly entered a parameter, or there is no room currently in the Host table for another IP
Address.
To Next Page
Loading...
