86 XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
1
selecting between 10 Base-T and Auto. If you have questions about your unit, contact H: Sales and
Customer Assistance (page 197).
To display the current Base-T setting, enter:
F100<S>BASET<CR>
where
The XLi responds:
F100 BASET 10T<CR><LF>
To set the Ethernet port to automatically negotiate the maximum connection speed, enter:
F100<SP>BASET<SP>AUTO
To set the Ethernet port’s connection speed to 10Base-T, enter:
F100<SP>BASET<SP>10
XLi responds:
OK <CR><LF>
RESETING THE UNIT<CR><LF>
PLEASE WAIT…<CR><LF>
F100 L/LOCK/UNLOCK – Remote Lockout
Use function F100 LOCK or UNLOCK to enable/disable remote access to the command line interface
through the network port. Use function F100 L to display the status of Remote Lockout. Remote Lockout
can also be set using F100 on the keypad/display interface. The factory setting is “Unlocked”. To unlock
remote lockout, use the keypad/display or the serial port’s command line interface (The network port is
not available because it has been locked).
Warning: F100 L and F100 LOCK terminates any active network sessions and prevents future
network sessions. To unlock F100 L or F100 LOCK, use the serial port command line
interface or the keypad display.
To lock the unit from a remote location, enter:
F100 LOCK<CR>
F
= ASCII character F
100 = unit function number
<S> = Space
BASET = specify Base-T command
<CR> = input line terminator
To Next Page
Loading...
Need help?
General
