Symmetricom XLi IEEE 1588 User Manual

162 XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
1
DESCRIPTION
"Total number of NTP packets rejected for any reason by NTP
application layer."
::= { ntp 3 }
ntpAuthFail OBJECT-TYPE
SYNTAX Counter32
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Total number of authentication failures. This is a subset of
ntpInErrors."
::= { ntp 4 }
ntpDesiredAcc OBJECT-TYPE
SYNTAX INTEGER (0..2147483647)
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"The desired (worst case time) accuracy in microseconds that the
time server will attempt to steer to. This variable is related to
ntpEstError. If ntpEstError is greater than ntpDesiredAcc, the
NTP alarm condition is set (ntpSysLeap will be equal to 3).
Note: Outgoing NTP packets will have their leap indicator field set to
ntpSysLeap."
::= { ntp 5 }
ntpEstErr OBJECT-TYPE
SYNTAX INTEGER (0..2147483647)
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"The time server's current estimated time error, in microseconds.
This variable is related to ntpEstError. Usually, this value
is small and constant for a given type of time server. However, when
primary synchronization is lost, this value slowly increases over
time as the time server's oscillator flywheels away from true time.
If ntpEstError exceeds ntpDesiredAcc, the NTP alarm
condition is set (ntpSysLeap will be equal to 3).
Note: a primary time server's outgoing NTP packets will have its leap
indicator field set to ntpSysLeap."
::= { ntp 6 }
ntpSysLeap OBJECT-TYPE
SYNTAX INTEGER
{
noLeapWarning (1),
lastMinuteHas61Secs (2),
lastMinuteHas59Secs (3),
alarmCondition (4)
}
MAX-ACCESS read-only
STATUS current
DESCRIPTION

Symmetricom XLi IEEE 1588 Specifications

General

Brand	Symmetricom
Model	XLi IEEE 1588
Category	Clock
Language	English