What should I do if the associated LED on the 4XZM does not activate for alarm, trouble, or supervisory conditions on System Sensor PDRP-1001 Control Panel?
If the associated LED on the 4XZM does not activate for alarm, trouble, or supervisory conditions, it could be due to an optional module trouble: 1. Make sure the module is properly installed. 2. Move the disable switch SW1 on the 4XZM to the left.
What to do if RZA-4X piezo doesn’t sound for alarm, trouble or supervisory conditions for System Sensor PDRP-1001 Control Panel?
If the RZA-4X piezo doesn’t sound for alarm, trouble, or supervisory conditions: 1. Make sure that the 4XLM module is installed on J7 and J8. 2. Check the field wiring.
Why do all RZA-4X LEDs stay on System Sensor Control Panel?
If all RZA-4X LEDs stay on, power wasn’t removed prior to installation. Hit the system reset.
General| Brand | System Sensor |
|---|---|
| Model | PDRP-1001 |
| Category | Control Panel |
| Language | English |
Lists the key features of the PDRP-1001/PDRP-1001A/PDRP-1001E control panel.
Details the input and output circuits of the control panel.
Explains the function and indication of each status LED on the control panel.
Details the function of the panel's control switches (Tone Silence, Alarm Silence, etc.).
Describes how zone status LEDs indicate alarm, trouble, and supervisory conditions.
Provides general guidelines for unpacking and mounting the control panel.
Outlines rules for separating and routing power limited and non-power limited wiring.
Explains wiring of alarm initiating devices for supervision and power limitations.
Describes configuration and wiring for notification appliance circuits.
Instructions for installing optional modules into the control panel.
Explains how to set the panel's operating mode using DIP switches.
Details how to configure the discharge timer settings using DIP switches.
To Next Page
