TGA 2950 EGA Furnace Option
TA I
NSTRUMENTS
TGA 2950 D–9
Figure D.3
Installing the EGA Mounting
Screws, Spacers, and Cleats
8. Tighten the upper two mounting screws
fully, then loosen each of them
no more than
one full turn, so that the flat sides of the
cleats are aligned vertically as shown in
Figure D.4.
Now tighten the lower two mounting screws
fully, then loosen each of them two full
turns, plus a fraction of a turn, so that the
flat sides of the cleats are aligned vertically
as shown in Figure D.4.
Cleat
Short Screw
Spacer
Cleat
Long Screw
To Next Page
Loading...
