TP9100 Service Manual Disassembly and Reassembly 103
© Tait Electronics Limited May 2005
5.2 Disassembling the Battery Catch
Reassembly is carried out in reverse order of the disassembly.
The circled numbers in this section refer to the items in Figure 5.2.
1. Undo the two screws
B and remove the battery catch support bracket
C.
Note The left battery catch
D and the right battery catch E are sym-
metrical but different parts.
2. Remove the left battery catch
D, the right battery catch E, and the
two springs
F.
Figure 5.2 Components of the battery catch
B
Torx T6 screw K1.8x5 PT (x2)
C
batter catch support bracket
D
left battery catch
E
right battery catch
F
battery catch spring (x2)
B
c
E
D
f
f
3600z_01
Torx T6
2lb·in (0.23N·m)
To Next Page
Loading...
