TP9100 Service Manual TPA-CH-001 Single Battery Charger 301
© Tait Electronics Limited May 2005
15.4 Disassembly/Reassembly
Disassemble only as much as necessary to replace the defective parts.
Reassembly is carried out in reverse order of the disassembly.
1. Unscrew the four corner screws
C and remove the bottom cover D.
2. Unplug the cable
F from the contact PCB J and remove the main
PCB
E and the light pipe G.
3. Unscrew the two screws
C holding the cradle I in place.
4. Remove the
I cradle and contact PCB J.
5. Unscrew the three screws
1) and remove the contact PCB J.
Figure 15.2 Parts of the single charger
Description IPN
B
rubber bumper (x4) 369-00010-11
C
screw P/T 30x10 (x6) 346-10030-10
D
bottom cover 346-10025-06
E
main PCB TPA-CH-M01
F
cable 219-02944-00
G
light pipe 262-00007-xx
H
top cover 303-23168-xx
I
cradle 303-30073-xx
J
contact PCB TPA-CH-M02
1)
screw P/T 25x6 (x3) 345-10025-06
Note:
The characters xx in an IPN (Tait Internal Part Number)
stand for the issue number of the part. Only the latest issue
of each part will normally be available for ordering as
spare or replacement parts.
Power adaptor T952-400
Mains cable
North America T952-340
Europe T952-330
United Kingdom T952-320
Australia/New Zealand T952-310
B
C
F
G
H
I
J
1)
E
D
To Next Page
Loading...
