TP9100 Service Manual TPA-AA-210 Hirose Accessory Adapter 317
© Tait Electronics Limited May 2005
18 TPA-AA-210 Hirose Accessory Adapter
Caution The radio produces a specific audio level at the max-
imum rated power. It is the sole responsibility of the
end-user to ensure applicability and compliance
with the relevant legal regulations defining the noise
level an individual can be subjected to.
The TPA-AA-210 Hirose accessory adapter is used to connect the
following recommended Hirose accessories, available from Tait
and OTTO Communications (www.ottoeng.com):
18.1 Connecting an Accessory
1. Verify that your accessory is compatible with the Hirose accessory
adapter, refer to Table 18.2.
2. When connecting an accessory, make sure it meets the following
specifications:
■ speaker impedance: 32Ω (16Ω min.)
■ speaker power: 0.25W
rms
(min.)
■ speaker configuration: single-ended
■ microphone: electret, approximately 1kΩ
■ PTT switch: not in series with microphone.
Table 18.1 Compatible Hirose accessories from Tait and Otto
Tait Part No. Otto Part No. Description
TPA-AA-211 V4BA1TP1 Light-duty breeze headset
TPA-AA-212 V4-10482 Heavy-duty BTH headset
TPA-AA-213 V1-10163 3-wire mini-lapel microphone kit (beige)
– V4-10190 Single-speaker headset
– V4-HC2MD3B Hurricane headset
– V1-T12MD137 Tactical throat microphone
– V1-10167 Earphone (beige)
– V1-10168 Earphone (black)
– V1-10165 2-wire palm microphone (beige)
– V1-10166 2-wire palm microphone (black)
– V1-10164 2-wire mini-lapel microphone kit (black)
– V1-10777 2-wire earbud kit
– V4-10279 Skull microphone
To Next Page
Loading...
