Tait TP9100 - Chapter 15: TPA-CH-001 Single Battery Charger

TP9100 Service Manual TPA-CH-001 Single Battery Charger 299
© Tait Electronics Limited May 2005
15 TPA-CH-001 Single Battery Charger
The TPA-CH-001 single battery charger is used to charge the
following Tait batteries:
■ TPA-BA-201 (NiCd)
■ TPA-BA-203 (NiMH)
The TPA-CH-001 single battery charger kit consists of the
following items:
■ single charger
■ 12V 3A power adaptor (T952-400)
■ Battery Care & Charging Guide
■ country-specific mains cable (may or may not be included)
15.1 Installation
Warning!! High voltage!
Only use the 12V 3A power adaptor (T952-400),
and the correct mains cable for your mains volt-
age.
1. Plug the mains cable into the 12V 3A power adaptor (T952-400).
2. Plug the power adaptor cable into the charger.
3. Plug the mains cable into the mains socket.
When power is first applied to the charger, all three LEDs should light up
for two seconds and then go out.
15.2 Charging the Battery
1. Ensure the charger is connected to the 12V 3A power adaptor
(T952-400).
2. Put the battery in the charger. (The radio, if attached, may be either
on or off.)
The red “Charging” LED glows to indicate that the battery is charg-
ing.
Note If the amber “Fault” LED lights up, refer to “Troubleshooting” on
page 300.
power adaptor
mains cable
single charger