Tait TP9100 - Page 114

114 Disassembly and Reassembly TP9100 Service Manual
© Tait Electronics Limited May 2005
Fitting the
PTT Keypad
The circled numbers in this section refer to the items in Figure 5.11 on
page 115.
1. Insert the blue PTT pressel
F and the two red function key pressels
G in the side of the front panel C.
2. Insert the PTT keypad
E into the PTT frame D.
3. Fit the PTT frame
D and the PTT keypad E to the front panel C by
first inserting the bottom tab, then bending the PTT frame slightly to
allow the top tab to slide in.
4. While pushing on the ridge between the PTT key and the lower
function key (
B), use pliers to fit the PTT lock spring B over the
PTT keypad’s T-shaped protrusion on the inside of the front panel
(see detail in Figure 5.11). The PTT lock spring can only be inserted
one way.