Functional Limit Level
Menu key Function
Functional Limit Level
(Initial value)
OPM
(Operation
mode)
NWM
(Network
mode)
1 Auto Color Change (AC) / Auto Start (AS).......54
Not to display
Key is invalid
2 Needle Bar Selection.......................................50
3 Data Conversion..............................................99
Not to display
4 Repeat ...........................................................105
5 Automatic offset.............................................173
6 Automatic Start after Automatic Data Set......108
7 Design position adjustment............................101
8 Continuous name...........................................127
10 Needle Bar Color .........................................146
1 Maximum RPM ................................................62
2 Total Stitch Counter / Design Timer...............145
Not to display
3 Frame Back/Frame Forward..........................156
4 Needle position specification FB/FF ..............159
6 Preset Halt.......................................................93
Not to display
7 Frame type.....................................................163
Not to display
9 Design start position ......................................180
10 Stop at Lower D. Point...................................96
1 Trace................................................................60
2 Manual Color Change......................................75
3 Manual Thread Trimming.................................77
4 Return to the design start position.................171
5 Manual Offset ................................................165
6 Return to the offset origin ..............................177
7 Forced Return Stitches..................................121
9 Frame Travel to an arbitrary position.............178
3 Manual return to marker position.....................76
9 Needle base LED light.....................................18
10 LED lamp.....................................................210
To Next Page
Loading...
