CONTROLS
Accessories
(7)
TUNE
button
Use this button to tune to a radio station.
Press and hold this button ( @ or
@)
) for
two seconds or more to start seeking the
audible stations. The seeking stops when a
station
is
found.
To
cancel tuning
in
progress,
press the button again.
Pressing the @ button will start seeking
stations with higher frequencies. Pressing
the
@)
button will start seeking stations
with lower frequencies. The frequency will
continuously be increased/decreased if the
@or@)
button
is
held pressed.
(8)
BAND button
Use this button to select
FM
or AM. The
selected band and the receiving frequency
will be displayed
on
the
LCD.
(9)
VOL buttons
Use these buttons to control the sound
volume. Press the button
@ to increase
the volume and the button
~
to decrease
the sound volume. Press and hold each
button to continuously increase/decrease
the volume.
(10)
MUTE
button
Use this button to temporarily turn off the
sound output. If pressed, the "mute
is
on"
mark
:l(
appears on the LCD. Press this
button again to cancel mute.
(11)
ZERO
button
Use this button to set the minute to "00"
when
it
is
between "
55
" to "59" or "01" to
"05".
(12)
AUX
button
Use this button to choose which to listen
to, the radio or
an
external audio source
connected to the AUX-IN. If the external
source
is
chosen, the AUX display appears
on the
LCD.
69
(13) AUX-IN
jack
Use this jack to connect
an
external audio
source.
Pull
off the rubber cap and plug the
stereo mini-plug of the external audio device
into this jack.
Be
sure that the jack
is
closed
with the rubber cap when not
in
use.
Playing the radio
1.
Turn
the ignition key to the ACC or
ON
position, and then press the power button
(1)
to turn on the radio.
2.
Select the band
FM
or AM with the band
button.
3. Select the station with the preset button or
the tuning button, and adjust the volume
with the volume button.
4.
To
turn off the radio, press the power
button.
Selecting a station - auto select
Press and hold the tune button @ for two
seconds or more to start seeking higher
frequency stations. Press and hold the
button
@)
for two seconds or more to start
seeking lower frequency stations. The radio
will stop seeking and start playing when it
finds
an
audible station.
Selecting a station - manual select
The selection can be done manually. Press
the tune @ button to seek stations with
higher frequencies. Press the
tune@)
button
to seek stations with lower frequencies.
Presetting stations
1 . Select the band
(FM
or
AM)
and the station
you want to preset.
2.
To
set the selected station to a preset
button, choose the button to be set and
then press and hold the button for three
seconds or more. The number
of
the
preset button chosen appears
on
the
LCD.
3. For more stations, repeat the steps
(1)
and
(2)
above.
To Next Page
Loading...
Need help?
General
