CONTROLS
Accessories
• If the preset button
on
which a station
has
been
set to
is
pressed and held
for two seconds or more, the preset
information will be modified.
• If the stored information
is
erased
during battery replacement
on
the
machine, set the stations again to the
preset buttons.
•
Each
preset button can store
information
on
one
FM
station
and
one
AM
station.
Auto storing
Press
the AST button for two seconds or
more while playing the radio.
The
radio
starts seeking the audible stations within the
band selected, stores the information
on
the
stations obtained into memory, and assigns
each preset button
(1
to
6)
a station.
Note: The previous station setting stored
in
memory will be overwritten. If the
arrangement of the preset buttons to the
corresponding stations
is
not desirable, try
the "Presetting stations" described above.
AUX
audio connection
• Connect a portable audio player and
listen
to
your favorite music.
•
Plug
a patch cord (without resistor) into
the headphone jack of the audio
player.
•
Plug
a stereo mini-plug
(3.5
mm)
into the
AUX-IN jack
on
the radio.
•
To
listen to the audio
player,
press the AUX
button.
(The
AUX display appears
and
the
frequency display
is
changed to the clock
display.)
•
To
return to the radio, press the
AUX
button again.
• When connecti
ng
, adjust the sound
volume
level
of the audio player so that it
is
same
as
that of the radio.
• Adjust the sound volume of the audio
player by using the volume control buttons
on
the radio.
70
•
Do
not connect a device with a larger
output than a portable audio
player.
Setting the clock time
•
Be
sure that the time
is
displayed
on
the LCD. If not, press the AUX button to
display the time.
•
Use
the
tune@
button to set the minutes.
Use
the tune @ button to set the
hour.
•
To
set the minute digits to "
00
" when they
are
from "55" to "59" or from
"01
" to "05",
press the
ZERO
button.
Resetting the radio
If there
are
any problems, such
as
the
abnormal display of frequency or failure of
selection, reset the radio by pressing the
power button and the
ZERO
button together.
Note that the memory containing the clock
setting and the channel setting
is
cleared
after reset.
To Next Page
Loading...
Need help?
General
