22
19
Menu Description
Regardless of where the MAIN icon is selected, transmission occurs only on the TX-
A/B frequency or channel of Segment A.
Regardless of where the MAIN icon is selected, transmission occurs only on the
Single
Mode
20
frequency or channel of Segment B.
In standby mode, only display one channel or one frequency.
OFF
A
In standby mode, the default setting displays two channels or two frequencies.
In channel mode, display the channel name.Channel Name
MDF-A21
In channel mode, display the channel name.
In channel mode, display the channel number.
VOX23
Turn off voice-operated transmission (VOX).
VOX
DELAY
24 From 0.5 to 2.0, with 0.1 increments as options.
Release the PTT without sending a shutdown code, typically used in relay transfer
25
to produce noise, confirming if the signal from the device is being relayed.
After releasing the PTT button, the device emits a shutdown code to suppress
the momentary noise at the receiving end.
Default is set to 90 degrees.
Number
120 degrees
180 degrees
240 degrees
Select the appropriate phase according to different repeaters to eliminate the
''click'' end tone.
TAIL
Turn off the ID code function.
PHASE
26
Menu Sub-menu (Options)
The MAIN icon indicates which frequency or channel will be transmitted.
If【 Side Key 2 】is set to PTT B, this function is disabled.
B
MDF-B22
STE
None
ANI
FUNC
-TION
27
OFF
ON
In channel mode, display the channel frequency.Channel Frequency
In channel mode, display the channel number.
Channel Number
In channel mode, display the channel frequency.
Channel Name
Channel Frequency
Channel Number
Activate voice control sensitivity, where level 1 is the most sensitive and level 9
is the least sensitive.
OFF
Level 1-9
0.5sec~2.0sec
OFF
ON
Transmit the device name simultaneously through signaling when transmitting.
OFF
ON
To Next Page
