23
28
Menu Description
DTMF
CODE
PTT-
Press the PTT button to transmit a DTMF code.
LT
29
Press and release the PTT button to transmit a DTMF code.
Delay time before automatic encoding.
OFF
Press PTT to encode
When transmitting through a repeater, after the sender releases the PTT button
and the device switches to receive mode, the delay from the repeater can cause
a momentary signal and noise to be received. Adjusting the value of this menu
item properly can prevent noise in the device during repeater transmission.
1-10s
RP-STE
If the noise is needed to confirm whether the repeater is working, this menu can
30
be turned off.
DTMFST32
The device emits the tone sound when keypad tones are used during transmission.
33
The device emits the tone sound during automatic ID transmission.
34
The device emits the tone sound for both keypad and automatic ID transmissions.
Plays a specific tone when Side Key 3 is pressed while pressing PTT.
No tone at the end of transmission.
TONE
Number Menu Sub-menu (Options)
Turn off DTMF encoding.
Encode simultaneously
RPT-RL31
S-CODE
( Squelch
Tail
Eliminate)
Turn off this feature if the noise is not needed.
1000hz
ROGER
0Ms、100Ms、
35
200Ms
400Ms、600Ms
800Ms、1000Ms
When relaying signals through a repeater, to confirm whether the repeater has
relayed the signal for the device, utilize the delay time when the repeater stops
transmitting. This allows the device to confirm that the signal has been relayed.
This menu item adjusts the duration of the noise that occurs for this confirmation.
No sidetone is emitted for keypad tones during transmission.
1-10s
PTT + ID
ID
Side-tone
The default end of transmission tone.
OFF
BEEP(End Tone)
Release the PTT button to transmit a DTMF code.
Release PTT to encode
OFF
OFF
OFF
1450hz
1750hz
2100hz
A distinctive signaling end tone.DC1200
To Next Page
