tBPC oCare Pro100 - Page 70

oCare
TM
Pro 100
70
distributor for
assistance.
Device enters
Sleep Mode
during
measurement
Sleep Mode is
activated during
measurement
Enter “SETTING”
to extend the
Idle-Time-to-Sleep
setting.
Device can’t
start the
continuous
recording
during
measurement
Remaining battery
is less than 10%
Charge the battery
full, and then enter
the continuous
recording.
Devices can’t
pair
Device is out of
BLUETOOTH
®
range
Verify device is in
BLUETOOTH
®
range while being
paired
(approximately 10
meters [32.8 feet]
spherical radius).
Radio frequency
interference (ex.
microwave)
Conduct the pairing
process away from
possible interference
source.
BLUETOOTH
®
radio has timed out
Turn the
BLUETOOTH
®
radio ON again in
“CONTROL”.