14
2 Safety
In common with all electrical equipment, the RBK processor must be used in accordance with established
safe working practices.
Prior to using the equipment, carefully read the Installation and Operating instructions (Section 4), together with
the following safety warnings.
2.1 General Warnings
Incorrect use of this equipment may cause injury.
This equipment must be operated and maintained only by fully trained and
qualified personnel. Operation should be according to this manual, so as to
avoid getting hurt.
Do not leave the equipment unattended during the process cycle.
Jamming of the operating mechanism may prevent the auto retraction of the
heater chamber. In this event the RBK processor heaters will switch off
automatically. Follow “Heater Carriage Jammed 4.2.10 and the Emergency
Heater Chamber Release” on 4.2.11
Failure to follow the manufacturer’s instructions may affect the equipment
warranty.
Do not use the equipment for cooking food or heating products other than
those recommended by TE Connectivity, especially avoid those products may
release hazardous gas after heating.
Due to the processor can reach up to 600°C,
do not operate the Equipment near
flammable and combustible environment.
Ensure adequate ventilation around the cooling fan intake and output grills a
minimum of 75mm clear space, when the equipment is in use.
Do not disassemble the equipment without guide or permission from TE.
To Next Page
Loading...