16
2.3 Personal Safety
2.3.1 Eyes
Eye protection must be worn at all times when the tool is in use.
2.3.2 Clothing
Care must be taken to ensure hair or loose clothing does not come into
contact with the Processor.
2.3.3 Fire Hazard
Parts of the tool will be hot during use. Special care must be taken to
avoid heating materials other than the pieces being worked on.
2.3.4 Hot Surfaces
It is recommended that protective clothing and gloves are used when
operating this tool
Do not touch the Processors heating chamber - during use, it will become
extremely hot.
Special care must be taken when handling finished wiring assemblies
immediately after ejection from the heating chamber.
Special care must be taken when handling the calibration UHI probe
immediately after ejection from the heating chamber.
2.3.5 Damage
Do not try to put hands into the safety guard, it could cause crush and cut.
2.3.6 Servicing
When carrying out repairs, always follow the instructions contained in this manual or contact TE Connectivity
for further advice. A record should be kept of the maintenance and servicing of the equipment.
Do not use substitute components, use only TE Connectivity approved parts. If the mains (utility) power
supply cord is damaged it must be replaced only by a special cord or assembly available from the supplier
or its agent.
To Next Page
Loading...