Techkon SpectroDens User Manual

15
CHAPTER 1 – How to use TECHKON SpectroDens
4. In the measurement function Automatic
Density, the device recognizes %-patches,
switches automatically to the display of the
dot area and shows the calculated values.
The automatic switch to %-values can also
be turned o using the device setting %
Measurement Automatic Density to avoid
switching caused by uctuation. When the
function is deactivated, the device will always
show the density values and the dot area will
not be calculated automatically.
5. SpectroDens can be connected to a WLAN
network to send information via wireless data
transmission to the PC. The WLAN module is
available as optional accessory.
6. Active Functions allows the user to per-
sonalize the device by disabling those of the
measurement functions that are not currently
needed. So the handling is concentrated on
the essentials. If necessary, the inactive mea-
surement functions are simply reactivated.
7. Sets the menu Language of the device.
8./9. All measurement values get a Date- and
Time-stamp. This information will be visible
when the data is transmitted to the PC soft-
ware SpectroConnect.
10. For the measurement of densities, the Dis-
play format CMYK can be selected.
The device can display two or three decimals.
The information in the chosen format is car-
ried out in all density modes.
Menu: Device settings
11./12. The functions Density adjustment
(SLOPE) and Absolute white reference val-
ues are for the internal device adjustment.
The device is correctly adjusted by the fac-
tory and changes of these settings should be
made only in special cases (see page 20 f.: Set-
ting of the Density adjustment (SLOPE)).
13. A Reset puts the device to factory settings.
Attention ! All stored measurement values
and a recently made calibration will be de-
leted and should therefore be saved on the
PC if necessary, by using the Windows soft-
ware SpectroConnect.
Only the factory-set calibration values are still
valid. A reset may be useful, if SpectroDens
does not work properly.
14. The information of Device Voltages is for
device diagnosis by service personnel.

Techkon SpectroDens Specifications

General

Brand	Techkon
Model	SpectroDens
Category	Measuring Instruments
Language	English