Device information and safety instructions
The use of this device in a dierent way than recommended by TECHKON GmbH
can endanger the device safety.
WARNING: This device may not be used in potentially explosive atmospheres.
Please protect your eyes and do not look directly into the optics when the device
is switched on.
Operating conditions: Ambient temperature: 10 to 35 °C, max. 30 to 85 % rel. humidity
(non-condensing); storage temperature: -20 to 50 °C.
Reset
A device reset sets the device back to factory settings. All calibration data (including
SLOPE values), stored measurement values, reference-, target-, and tolerance-values
will be deleted.
If the reset procedure in the settings window is not possible, a hardware reset has to
be carried out. The battery plug has to be unplugged for a couple of seconds and then
to be connected again.
Warranty
The warranty for TECHKON products is 24 months starting with the date of purchase.
Consumable and wearing parts are excluded from this. The invoice is the certicate
of warranty. The warranty is invalid if the damage is caused by inadequate use of the
device.
Should a TECHKON product do not work according to the specication, please contact
us before sending us the device. In most cases we can solve the problem over the
phone or via E-mail.
Inspection intervals
TECHKON SpectroDens is maintenance free. We recommend to validate the com-
plete functionality of the devices in a 24 months time interval in the TECHKON ser-
vice center.
Please send the device always securely in the carrying case with complete accessories.
For a at fee the device will be cleaned, checked and re-calibrated. In case a repair or
exchange of components should be necessary we will inform you in advance.
To Next Page
Loading...
Need help?
General