G7™
The measurement function G7™ supports the calibration of presses and proofs ac-
cording to the method developed by the IDEAlliance (International Digital Enterprise
Alliance).
The G7™ mode can be selected out of the list
of measurement functions.
In the pop-up window of the measurement
conditions the item G7™ Setup can be cho-
sen. Now target values can be edited and
printing conditions can be selected.
Edit the target values for SC, HR and HC for
K and CMY. For Auto Set a*/b* use half a*/b*
values of measured paper as target value.
You will nd a comprehensive description of
the SCCA function on page 59.
For the comparison to the right ISO reference
values the used paper type must be selected.
To Next Page
Loading...
Need help?
General