Techmaster T9530 - 7.6. Dynamic Code Opening (PIN); 7.7. Dual Mode Opening without Time Delay

IU_TechMaster_02_eng Page 27 of 32
7.6. Opening the lock with Dynamic Codes (PIN option)
Power up TechMaster (select the lock if two or more locks are
installed).
LCD will display the message:
USER CODE
X X – X X X X X X
Press and hold button number 1. LCD will display the message:
PIN
X X X X
Enter your four digits PIN. LCD will display the message:
DYNAMIC USER
X X X X X X X X X
Enter the Dynamic Code generated by software and press .
Invalid Dynamic code will prompt the LCD to display the message:
WRONG
DYNAMIC CODE
If the Dynamic Code is entered 30 minutes before his activation time
LCD will display the message:
DYNAMIC CODE
BROUGHT FORWARD
If the Dynamic Code is entered 30 minutes after his activation time
LCD will display the message:
DYNAMIC CODE
EXPIRED
Dynamic Codes must be used respecting the sequence of activation
time in which they have been created by the software, otherwise the
last created code will delete all the previous ones (i.e. if three codes
are created and the third one is used before the first and the second
ones, the two first codes will be deleted). LCD will show the message:
DYNAMIC CODE
UNUSABLE
Enter the Dynamic Code. LCD will display the message:
OPEN
Open the door within 3 seconds.
Before power-off, LCD will display current date and time.
11:44 WED
01 / 09 / 2010
7.7. Dual Mode: Opening the lock without Time Delay
Power up TechMaster (select the lock if two or more locks are installed).
LCD will display the message:
USER CODE
X X – X X X X X X
Enter a valid user code and insert the Dallas key, if set-up. LCD will
display the message:
2° USER CODE
X X – X X X X X X