Technics SC-HDV600 User Manual

Settings
44
RQT5941
Reference
Speaker settings
Refer to “Changing the settings” (\ page 41).
For the United Kingdom
Do these settings if you connect center and surround speakers.
For others
You can enjoy multi-channel audio from DVDs without doing these
settings. Change them to improve the effect or when you connect a
subwoofer.
Speaker mode (United Kingdom only)
Set the presence and size of the speakers you have connected.
The sound for a speaker channel will not be output if you set the
presence incorrectly.
You will not get the most from your speakers if you set the size
incorrectly.
ı shows the default screen for the United Kingdom.
Use illustration Å as a guide to select the center and surround
speakers.
1 Press the cursor buttons (werq) to select
the speaker and press [ENTER].
2 Press the cursor buttons (e or r) to change
the setting.
The speaker icon appears.
3 Press [ENTER].
This confirms the size of the speaker, small or large, and the
icons for speaker balance (“dB”) and delay time (“ms”)
appear.
¡Set to “small” if you connect the recommended optional center
and surround speaker system (SB-PT96).
¡You cannot change the size and presence of the front speakers
(L and R) or the subwoofer (SW).
Note
Channel balance
1 Press the cursor buttons (werq) to select
“Test” and press [ENTER].
A test signal is output in the following order:
L / C / R / RS / LS
2 Press the cursor buttons (e or r) to adjust
the level while the speaker is outputting the
signal.
3 Press [ENTER ] to stop the test signal.
To adjust subwoofer output
After playing a source to determine the approximate level, stop play
and return to this screen to adjust the level to your taste.
,
SELECT
ENTER
RETURN
SETUP
R
L
C
LS
RS
O
ms
O
dB
O
dB
O
ms
O
dB
O
dB
SW
Exit
Test
(LS)
(RS)
Exit
Test
signal
Center speaker
Subwoofer
Surround speakers
A
A
Adjust the balance of the center and surround speakers using the
test signal so that they are the same apparent level as the front
speakers when you are sitting where you would normally enjoy a
source. First adjust the unit’s volume to the level normally used.
SpeakersIcon
O
dB
Center
Surround (LS) Surround (RS)
Subwoofer
When you have finished changing the settings
Press the cursor buttons to select “Exit” and press [ENTER].
SLEEP
CLOCK/
TIMER
PLAY MODE
A-B REPEAT
REPEAT
AUTO/MONO
DVD/CD
TAPE
EXT
TUNER
MUTING
CANCEL
123
456
≥10/-/--
7890
SUB TITLE
AUDIO
ANGLE
MENU
TOP MENU
SETUP
DISPLAY
RETURN
ENTER
SKIP
SLOW/SEARCH
SHIFT
q
w
e
r
ENTER
CANCEL
SELECT
ENTER
RETURN
SETUP
R
L
O
dB
SW
Exit
Test
B
Icon
Yes (large) Yes (small) No
LS
LS
United Kingdom only
Example: Left surround speaker (LS)

Technics SC-HDV600 Specifications

Front Speaker Specifications

impedance (high)	6 Ω
impedance (low)	6 Ω
input power (high, music)	30 W
input power (high, DIN)	15 W
input power (low, music)	60 W
input power (low, DIN)	30 W
output sound pressure level	87 dB/W (1.0 m)
cross over frequency	5 kHz
frequency range (-16 dB)	48 Hz–50 kHz
frequency range (-10 dB)	55 Hz–45 kHz
dimensions (W × H × D)	160 × 334 × 222 mm
mass	3.5 kg

Surround Speaker Specifications

impedance	8 Ω
input power (music)	70 W
input power (DIN)	35 W
output sound pressure level	84 dB/W (1.0 m)
frequency range (-16 dB)	130 Hz–20 kHz
frequency range (-10 dB)	150 Hz–18 kHz
dimensions (W × H × D)	140 × 99 × 118 mm
mass	0.9 kg

Center Speaker Specifications

impedance	8 Ω
input power (music)	160 W
input power (DIN)	80 W
output sound pressure level	86 dB/W (1.0 m)
cross over frequency	4 kHz
frequency range (-16 dB)	100 Hz–22 kHz
frequency range (-10 dB)	115 Hz–20 kHz
dimensions (W × H × D)	190 × 99 × 166 mm
mass	1.8 kg

Tuner Specifications

FM frequency range	87.50–108.00 MHz
FM antenna terminal	75 Ω (unbalanced)
AM frequency range (9 kHz step)	522–1629 kHz
AM frequency range (10 kHz step)	520–1630 kHz
dimensions (W × H × D)	210 × 76.3 × 251 mm
mass	1.1 kg

Amplifier Specifications

low frequency power output (stereo mode, RMS 1 kHz)	2 × 17 W
high frequency power output (stereo mode, RMS 10 kHz)	2 × 8 W
low frequency power output (multichannel mode, RMS 1 kHz)	2 × 10 W
low frequency power output (multichannel mode, DIN 1 kHz)	2 × 8 W
high frequency power output (multichannel mode, DIN 10 kHz)	2 × 6 W
high frequency power output (multichannel mode, RMS 10 kHz)	2 × 8 W
surround, center power output (DIN 1 kHz)	3 × 6 W
surround, center power output (RMS 1 kHz)	3 × 8 W
total harmonic distortion (half power, 1 kHz)	0.07%
load impedance (low frequency)	6 Ω
load impedance (high frequency)	6 Ω
load impedance (surround, center)	8 Ω
S/N	78 dB
headphones load impedance	16–32 Ω
power supply (United Kingdom)	AC 230–240 V, 50 Hz
power supply (others)	AC 230 V, 50 Hz
power consumption	110 W
standby power consumption	0.9 W
dimensions (W × H × D)	210 × 104.8 × 300 mm
mass	3.5 kg

DVD Video Player Specifications

signal system	PAL(PAL 60/NTSC)
output level (composite video)	1 Vp-p
output level (S-Video Y)	1 Vp-p
output level (S-Video C, PAL)	0.3 Vp-p
output level (S-Video C, NTSC)	0.286 Vp-p
pick up wavelength	658/790 nm
dimensions (W × H × D)	210 × 76.3 × 295 mm
mass	1.5 kg

Cassette Deck Specifications

frequency response (TYPE 1)	30 Hz–16 kHz
frequency response (TYPE 2)	30 Hz–16 kHz
frequency response (TYPE 4)	30 Hz–16 kHz
S/N (NR off)	56 dB
S/N (Dolby B NR)	64 dB
wow and flutter	0.1% (WRMS)
dimensions (W × H × D)	210 × 104.8 × 241 mm
mass	1.6 kg