ROTEX 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.16
7.15. DISASSEMBLING THE REAR COVER
Figure 7.15-1
1. Turn off the machine and unplug the mains
lead from the wall output.
2. Turn the machine over on one side.
3. Back off the 4 nuts a using a 19 mm wrench.
Support the REAR GUARD before
backing off the last screw.
4. Return the machine to the upright position.
Figure 7.15-2
5. Align the pedals as shown in the figure.
6. Pull up on the REAR COVER, which snaps
onto the frame.
When removing the REAR COVER, be
careful not to knock it against the
pedals.
To reassemble the REAR COVER, carry out the
above steps in reverse order.
Before locking down the nuts of the
REAR GUARD, adjust its lengthwise
positioning, making sure that the levers
do not touch it when they are moved.
To Next Page
Loading...
