EasyManua.ls Logo

Technomark M4 inline - Dot Matrix Selection

Technomark M4 inline
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 14 of 44
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Version from 04/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
5.2.6. Control unit
Illustration 11: M4 inline control unit
5.2.7. Control unit power cable (depending on country)
The power cable supplied with your machine meets the standards and guidelines applicable to the equipment for
which it was tested.
5.2.8. Sub-D 25 connector
In order to connect to the M4 inline control unit 16-way card, a Sub-D 25 point male connector kit is supplied which
must be screwed in place.
See paragraph 8.2.4 Cabling the for a cabling diagram or refer to the manual Interfacing instruction for M4 inline.
Illustration 12: Sub-D 25 point connector kit

Table of Contents

Other manuals for Technomark M4 inline