TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
6.2.3. Marking window
The machine below is shown in solid lines when in the original position, and in dotted red lines where the impact
unit reaches the bottom of the window (position X and maximum at Y).
The overall dimensions and the dimensions of the labelling window identified by Wx are variable, depending on the
machine's window size as well as the original X position (Ox). Specific plans for each size are attached.
However the Y dimensions of the marking window remain the same for all window sizes: 55mm (2.165in).
Illustration 20: Marking window in Y
Illustration 21
: Marking window in X (rear view of machine)
To Next Page
Loading...
