Technomark M4 inline - Serial Number Configuration

Page 16 of 44
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Version from 04/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
6. General presentation of the machine
6.1.Control unit
6.1.1. Dimensions
Illustration 15: Dimensions of M4 inline control unit
6.1.2. Connector description
Illustration 16: Presentation of control unit connectors (rear view)
Connector description
1. Marking head connector
2. Power plug and ON / OFF switch
3. 12 point accessory connector
4. Sub-D 16-way 25 point female
connector
5. Ethernet Port (RJ45)
6. USB Device
7. Female serial port (RS232)
In case of a machine integrated into a system, control box must be turned off before connecting or
disconnecting the 16-way connector to prevent unexpected piloting and damaging the installation.
In
The control unit must be turned off before connecting or disconnecting the power, the header connector, the
accessory connector
and 16-way connector.
Otherwise there is a risk of irreversible material
damage.
External circuits connected to the product must be a SELV design, as defined in the IEC60950
-
1:2005 and
EN60950-1:2006/+A11 standards.
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th
Th