TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
8.1.3. Attaching the head
By default your equipment comes with a standard M4 inline fixing kit. It is recommended that this is used for
fastening your machine (Other types of accessories are available, see 7 List of available accessories and options).
The marking head will be attached by the rear or the top depending on whether or not it has the NOI0-0001 option
(See 6.2.1 Possible configurations ).
8.1.3.1. Rear attachment – default machine configuration
Illustration 33: Head attachment – default machine configuration
M4 x 20mm M6 hex head screws (ref. S) are supplied with the machine for this attachment.
The following information is given for machines equipped with standard styluses and guides. The impact unit is
in the original position.
The marking head must be attached in accordance with accepted trade practices.
If the head is attached without using accessories provided by Technomark, incorrect assembly
could result in
damage to the equipment and the cancellation of the guarantee. It is preferable to contact Technomark for
validation of installation conditions.
To Next Page
Loading...
