EasyManua.ls Logo

Technomark M4 inline - Settings; General Settings Configuration

Technomark M4 inline
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 38 of 44
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Version from 04/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
To install the brackets the rubber feet used for vertical installation of the control unit must be removed. The 4 CHC
M4 × 8mm screws can be unscrewed with a size 3 Allen key.
Illustration 40: Dismantling the vertical installation feet
The side plates are fastened with FHC M4 × 8mm screws using a size 2.5 Allen key.
Illustration 41: Attaching the rack mounting bracket (1/2)
Illustration 42: Attaching the rack mounting bracket (2/2)

Table of Contents

Other manuals for Technomark M4 inline