TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
6.3.Normal operating conditions
· Power supply: 90-240 V single phase ~ 3.4A 50/60 Hz
· Temperature: 0 – 45°C
· Humidity: 0 – 90%
· Electromagnetic compatibility (C.E.M):
o EN55022 (2006 +A1/2007)
o EN55024 (1998 + A1/2001 + A2/2003)
o EN 61000-6-2 (2005)
· Electrical safety:
o IEC 69950-1 :2005 +/A1 :2009
o EN 60950-1 :2006 +/A11 :2009 +/A1 :2010 +/A11 :2011
Your M4 inline marking machine has unreservedly been approved, and the certified test report is available upon
request.
When used intensively the active part of the machine (impact unit solenoid) may exceed a temperature of 70°
C. Do not work on this element without adequate protection and/or letting it cool before servicing.
This is a Class A product. In a domestic environment this product may cause radio interference, in which case it
is possible that the user wil
l be required to take adequate measures to eliminate the interference.
unit's power supply must be equipped upstream with a grounded 30mA residual-
current circuit
breaker, with 16A maximum protection.
The building's electrical system will provide protection from ground faults.
This equipment has been tested and found to comply with the limits for a Class A digital device, according to
FCC
rules, Part 15. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency waves, and if not installed and used according to the instructions in the instruction
manual may cause harmful interference to radio communications. The use of this equipment in a residential
area is likely to produce harmful interference, in which case the user will be required to correct the
interference at his own expense.
To Next Page
Loading...
