Technomark M4 inline - 2 D Code (Datamatrix;QR) Configuration

Page 22 of 44
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Version from 04/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
7.4.Styluses and stylus guides
7.4.1. Styluses
Depending on your requirements there is a wide choice of styluses, defined by their length, angle of sharpening and
use (aeronautics or other).
Reference
Description
TKF053A-60
60mm (2.36in) carbide stylus sharpened to 90° (standard model)
TKF053A-60AE
60mm (2.36in) carbide stylus sharpened to 90° (aeronautics)
TKF053B-60
60mm (2.36in) carbide stylus sharpened to 60°
TKF053B-60AE
60mm (2.36in) carbide stylus sharpened to 60° (aeronautics)
TKF053D-60
60mm (2.36in) carbide stylus sharpened to 120°
TKF053D-60AE
60mm (2.36in) carbide stylus sharpened to 120° (aeronautics)
TKF053A-100
100mm (3.94in) carbide stylus sharpened to 90°
TKF053A-100AE
100mm (3.94in) carbide stylus sharpened to 90° (aeronautics)
TKF053B-100
100mm (3.94in) carbide stylus sharpened to 60°
TKF053D-100
100mm (3.94in) carbide stylus sharpened to 120°
TKF053D-100AE
100mm (3.94in) carbide stylus sharpened to 120° (aeronautics)
7.4.2. Stylus guides
The appropriate guide must be used for the chosen stylus length:
· 60mm length: Stylus guide for 60mm (2.36in) – Reference TKF052A-60 (standard model)
· 100mm length: Stylus guide for 100mm (3.94in) – Reference TKF052A-100