TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
8.1.1.2. Possible integration orientations with validation from technical services
The following integration orientations and their combinations require validation from technical services.
Illustration 26: Integration orientations requiring validation (1/2)
For the following integration orientations, the integrator must put in place the necessary measures to avoid
any solid and liquid material being projected toward the
machines.
The integration should take into account all the constraints related to this position.
Inspections and regular cleaning with an air blower may be necessary to remove any deposits and
accumulations of material on the device and its guides (refer t
o the M4 inline Maintenance Manual
for
maintenance frequency) .
When the stylus is integrated upwards, inspections and cleaning should also include the
impact unit
M4 inline Maintenance Manual for maintenance frequency)
Inspection and maintenance recommendations based on the type of integration must be communicated to the
end user by the integrator in order to maintain the equipment in good working condition.
To Next Page
Loading...
